Detailed Information

Cited 12 time in webofscience Cited 13 time in scopus
Metadata Downloads

Electro-catazone treatment of an ozone-resistant drug: Effect of sintering temperature on TiO2 nanoflower catalyst on porous Ti gas diffuser anodes

Authors
Li, XinyangLi, YannanZhang, HaoShen, ZhenCheng, ShuangLiu, GuichengYao, Hong
Issue Date
Oct-2021
Publisher
ELSEVIER SCIENCE INC
Keywords
Electrochemical; Ozonation; Sintering temperature; Crystallized phase; Interface reactions
Citation
CHINESE CHEMICAL LETTERS, v.32, no.10, pp 3221 - 3225
Pages
5
Indexed
SCIE
SCOPUS
Journal Title
CHINESE CHEMICAL LETTERS
Volume
32
Number
10
Start Page
3221
End Page
3225
URI
https://scholarworks.dongguk.edu/handle/sw.dongguk/4387
DOI
10.1016/j.cclet.2021.03.072
ISSN
1001-8417
1878-5964
Abstract
Electrochemical heterogeneous catalytic ozonation (E-catazone) is a promising and advanced oxidation technology that uses a titanium dioxide nanoflower (TiO2-NF)-coated porous Ti gas diffuser as an anode material. Our previous study has highlighted that the importance of the TiO2-NF coating layer in enhancing (OH)-O-center dot production and rapidly degrading O-3-resistant drugs. It is well known that the properties of TiO2-NF are closely related to its sintering temperature. However, to date, related research has not been conducted in E-catazone systems. Thus, this study evaluated the effect of the sintering temperature on the degradation of the O-3-resistant drug para-chlorobenzoic acid (p-CBA) using both experimental and kinetic modeling and revealed its influence mechanism. The results indicated that the TiO2-NF sintering temperature could influence p-CBA degradation and (OH)-O-center dot production. TiO2-NF prepared at 450 degrees C showcased the highest p-CBA removal efficiency (98.5% in 5 min) at a rate of 0.82 min(-1), and an (OH)-O-center dot exposure of 8.41 x 10(-10) mol L-1 s. Kinetic modeling results and interface characterization data revealed that the sintering temperature could alter the TiO2 crystallized phase and the content of surface-adsorbed oxygen, thus affecting the two key limiting reactions in the E-catazone process. That is, =TiO2 surface reacted with H2O to form TiO2-(OH)(2), which then heterogeneously catalyzed O-3 to form (OH)-O-center dot. Consequently, E-catazone with a TiO2-NF anode prepared at 450 degrees C generated the highest surface reaction rate (5.00 x 10(-1) s(-1)and 4.00 x 10(-3) L mol(-1) s(-1), respectively), owing to its higher anatase content and adsorbed oxygen. Thus, a rapid O-3-TiO2 reaction was achieved, resulting in an enhanced (OH)-O-center dot formation and a highly effective p-CBA degradation. Overall, this study provides novel baseline data to improve the application of E-catazone technology. (C) 2021 Chinese Chemical Society and Institute of Materia Medica, Chinese Academy of Medical Sciences. Published by Elsevier B.V. All rights reserved.
Files in This Item
There are no files associated with this item.
Appears in
Collections
College of Natural Science > Division of Physics & Semiconductor Science > 1. Journal Articles

qrcode

Items in ScholarWorks are protected by copyright, with all rights reserved, unless otherwise indicated.

Altmetrics

Total Views & Downloads

BROWSE